Automatic search

Most Nobø receivers, plus a few Orion700 products (R80 RSC-700, R80 TXF-700, TCU700 room thermostat, Safir glass heater) can connect to the APP and Nobø HUB by automatic search.

Select “automatic search” in the APP. Next, you will be asked to switch on your system unit, and the unit will send its ID-code to Nobø HUB. More than one unit can be connected at once. Just switch on one unit, and check that it appears in the APP overview before switching on another. The search can be paused if needed.

It is advised to register one zone at a time.

How to switch on a receiver/transmitter for Automatic Search

NCU-1R, NCU-2R, NCU-ER: insert the unit into the heater. Turn the heater’s power switch from OFF(0) to ON(1). 

NTB-2R Room and floor thermostat: Slide the switch from standby to on.

R80 RSC700, R80 TXF700: insert the unit into the heater. Turn the heater’s power switch from OFF(0) to ON(1).

TCU700: Press and hold the right button until the menu appears. Press down and select EC700. Press the right button again to confirm the selection. TCU700 will then connect to your Nobø HUB or Orion700 control unit. 

Safir: Turn the heater’s power switch from OFF(0) to ON(1).

Nobø Switch SW4: Press the center of the switch once, so that all four corners are pressed down. The switch light flashes while searching for ECOHUB

R80 RDC 700 og R80 RXC 700: Require manual registration.

2NC9 700: Requires manual registration.

TRB700, TXB700: Require manual registration.

RCE 700, RS700 og RSX700: Require manual registration.