Name and assign units to a zone

When one or more ID codes are registered, each unit should be given a name. Enter a name that is easy to recognise. E.g. “Heater Dining room”, “Underfloor heating Bath” etc.

Every unit must be assigned to a zone. A unit will be added to the previously selected zone, unless you choose a different zone in the drop down menu. A new zone can also be added via the drop down menu. Give the zone a name that is easy to remember. E.g. “Heat Living room”. 

Assigning a zone to Nobø Switch

Nobø Switch has two possible configuration modes: Global control or Local zone control. When adding a Nobø Switch to the system, the preferred configuration mode is selected. Global control, enables the switch to control all zones. Local zone control enables Nobø switch to control one specific zone.

1. Global Control:

   When configured as a Global control, Nobø Switch overrides and controls any unlocked zones in the system. A Global Nobø Switch has the same functionality as the circle meny in the home screen. Select "Global control" in the unit setup screen to assign this functionality to a switch. At the same time, Nobø Switch can be used as a temperature sensor in a zone. The zone can be selected in the drop down menu. 

   

2. Local zone control:

   When configured as a Local zone control, Nobø Switch is connected to one specific zone. Any overrides or operations from the switch only affects the connected zone. Select "Local zone control" in the unit setup screen to assign local control to the switch. The zone is selected in the drop down menu. As an option, Nobø Switch can also be used as a temperature sensor in the same zone.